컨텐츠 바로가기


  • 신제품
  • 입문자 상품/시물레이션
  • DJI 드론
  • 비행기&교체파트
  • 비행기부품/악세사리
  • 비행기공구
  • 엔진
  • 연료/시동장비
  • 조종기/악세사리
  • 서보&파트
  • 모터/악세사리
  • 변속기/악세사리
  • 배터리/컨넥터/악세사리
  • 접착제/경화제/기타
  • 공구
  • <font color=red>가솔린기체 필수 부품
  • Flash Sales
  • EPP 전동기체모음전
  • 충전기/악세사리
  • 볼트/너트/와셔
  • 가방/박스

  • 공지사항
  • 상품 사용후기
  • 기체 제작기
  • 비행일지
  • RC TIP
  • 3D비행술

고객센터



 

[구매 대행 상품&무료배송]32CH 600w 5.8G RC832+TS832 영상송수신기 콤보세트 (해외배송 가능상품)

기본 정보
제조사 FatShark
원산지 CHINA
판매가 ₩75,000
상품코드 7217
수량 수량증가수량감소
SNS 상품홍보
SNS 상품홍보

개인결제창을 통한 결제 시 네이버 마일리지 적립 및 사용이 가능합니다.

상품 옵션

(최소주문수량 개 이상 / 최대주문수량 개 이하)

수량을 선택해주세요.

위 옵션선택 박스를 선택하시면 아래에 상품이 추가됩니다.

상품 목록
상품명 상품수 가격
[구매 대행 상품&무료배송]32CH 600w 5.8G RC832+TS832 영상송수신기 콤보세트 수량증가 수량감소 75000 (  0)
총 상품금액(수량) : 0 (0개)
바로구매하기 장바구니 담기 SOLD OUT 관심상품등록
THIS IS THE NEW 32-CHANNEL EDITION OF 5.8G 600mW A/V WIRELESS SYSTEM.

Features:

32 channels: Cover A, B, E bands and F band (Airwave band), 4 bands and all frequencies compactable;
• Two switching buttons: CH button for frequencies channels switching, FR button for frequencies bands switching;
Two digits display: one for CH and the other for FR, real-time positioning which frequency band and which channel received;
• Power off memory: Replay the very last frequency band and channel
• Independent video and audio signal outputs



Specifications:

FPV 5.8G 600mW A/V Transmitting/Receiving System TS832 + RC832 - 32CH Edition | RP-SMA

video format supported: NTSC/PAL
Antenna connection: RP-SMA, jack (module side, both TX and RX)

TX TS832 specs:
Power input: 7.4-16V (3S Lipo suggested)
Transmitting power: 600mA
Antenna gain: 2db
Working current: 220mA at 12V
Video bandwidth: 8M
Audio bandwidth : 6.5M
Weight: 22g
Dimension: 54x 32x 10mm(excluding antenna)

RX RC832 Specs:

Power input: 12V
Working current: 200mA max
Antenna impedance: 50Ω
Antenna gain: 2db
Video impedance: 75Ω
Video format: NTSC/PAL auto
Dimension: 80x 65 x15mm
Weight: 85g


*Note: TX antenna must be installed properly before it is switched on, power on without install antenna, or a improper antenna was used may easily burn the TX, and such damage is not covered by warranty.






* We found that in recent batch, some of the TX TS-832 come with reversed power supply wires, the first wire from left side is black instead of red, but we also noticed that for the ones with reversed wires, the wires on JST connector side are also reversed, so in this case, if you connect the JST connector to a battery pack with standard polarity JST connector, as both the sides are reversed, so the system can still work properly, but in this case, the black wire is for "Positive" pole, and the red wire is for "negative". In other words, if the first wire from left on the TX module side is black instead of red, then on JST side, the black wire should be connected to the Positive pole of your battery.

The key point is that the first wire/pin from left side as shown on above diagram must be connected to "positive" pole of your power source, so if the wire color mapping is not critical for you, you can leave it without any change for the "wrong" cables, also this TX module with wrong polarity protection, it will not damage the TX even in case the power supply is in wrong polarity.

For the ones who concern about the color/polarity mapping issue too much, you can follow the below diagram to swap the wires:






Includes/Requires:

Includes:
1 x transmitting unit (TX)
1 x receiver (RX)
2 x antennas (2db)
1 x basic wires set


게시물이 없습니다

상품문의하기 모두 보기

게시물이 없습니다

상품문의하기 모두 보기


자유 게시판

자유 게시판
제목 날짜
OS 엔진 입고안내! 06-15
Toprcmodel 입고예정일 안내~ 03-27

맨위로

이전 제품

다음 제품